Keys Fitness KF-T2-0 User Manual download pdf (Page 29)

www.keystness.com

Belt Adjustment

WARNING! Do not over-tighten rollers! This will cause premature roller bearing failure!

Belt adjustment and tension performs two functions: adjustment for tension and centering. Your new

treadmill comes pre-adjusted from the factory for tension and centering. Please follow the procedures

below if the belt shifts to the left or right while walking:

WALKING BELT IS SHIFTING TO THE LEFT

(Diagram 1)

First, turn treadmill on to run at 1 mph. Using the hex key provided, turn the left rear roller adjustment

bolt ¼ turn in the clockwise direction. Next, run the treadmill at 2.5 mph. You should see the belt start to

correct itself by moving back toward the center. Repeat the above procedure until the walking belt is cen-

tered. It may be necessary to set walking belt tension once you have completed this procedure if the belt

feels like it is slipping while walking. Refer below to the “Walking Belt Slipping” instructions.

WALKING BELT IS SHIFTING TO THE RIGHT

(Diagram 2)

First, turn the treadmill on to run at 1 mph. Using the hex key provided, turn the right rear roller adjust-

ment bolt ¼ turn in the clockwise direction. Next, run the treadmill at 2.5 mph. You should see the belt

start to correct itself, moving back toward the center. Repeat the above procedure until the walking belt is

centered. It may be necessary to set walking belt tension once you have completed this procedure if the

belt feels like it is slipping while walking. Refer below to the “Walking Belt Slipping” instructions.

WALKING BELT IS SLIPPING DURING USE (Diagram 3)

First, unplug the power cord from the surge protector. Using the hex key provided, turn both left and

right rear roller adjustment bolts the same distance, usually a ¼ turn, in the clockwise direction. Plug the

power cord back into the surge protector and run the treadmill at 2.5 mph. You should now walk on the

belt to determine if the belt is still slipping. Repeat the above procedure until the walking belt is not slip-

ping. The tension should be just tight enough not to slip.

Note: Turning the hex key clockwise brings the rear rollers and belt towards you.

Turning the hex key counter clockwise pushes the rear roller and belt away from you.

Belt Adjustment

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 35 36

No comments

Keys Fitness KF-T2-0 User Manual Page 29